1. Welding welders must have a welding qualification certificate, and the welding grade should meet the corresponding welding technical requirements.

2、對接焊縫的焊接，焊縫采用單麵焊、雙麵成型工藝，DN≥600mm時，應在管內進行封底焊。

2 welding, butt welding, welding by one side welding and double forming process, DN should be greater than or equal to 600mm, sealing welding in the tube.

3、卷管組對焊接，兩縱焊縫間距應大於100mm。

3, pipe butt welding, two longitudinal weld spacing should be greater than 100mm.

4、大口徑的麻豆视频官网焊接，采用雙人對稱焊接。

4, large diameter pipe welding, the use of double symmetrical welding.

5、卷焊管製作完畢後，應采用角鋼支撐，防止產生塑性變形。

5. After the coil welding pipe is finished, the angle steel should be used to prevent the plastic deformation.

6、麻豆视频官网焊接後必須對焊縫進行外觀檢查，表麵不得有裂縫、氣孔、夾渣等缺陷，吸肉深度不得大於0.5mm。不合格者，不得出廠。

6. After the pipe welding, the appearance of the weld must be examined. There must be no cracks, holes, slag and other defects on the surface, and the depth of meat absorption should not be more than 0.5mm. A person who is not qualified shall not be out of the factory.

7、預製好的管段，應將內部清理幹淨，封閉管口，防止雜物進入。

7, prefabricated pipe section, should clean the interior, close the pipe mouth, to prevent the entry of debris.

8、管段預製完畢後要及時編號，妥善保管。根據實際情況分批運現場。

8, the pipe section should be numbered in time after the completion of the prefabrication. It is transported to the site in batch according to the actual situation.